Lacy curtains usually darn. But it occupies a lot of time, and the darned places spoil a kind of curtains. Better slices from the old curtains, corresponding to a pattern to wet in starch and to paste on the damaged place of a curtain from a wrong side, then to smooth a hot iron.
Woolen woven things can be repaired as follows: to shift as it is possible more close rupture edge, to take a slice of the same matter, densely to smear its egg white and to enclose under the broken off place, then to iron from a wrong side a hot iron.
It is possible to stick the Damaged site of any thing with glue "-И-6". The prepared patch humidify and press. A zaplatochnyj rag put under the damaged place a face sheet upwards and through an aperture in a fabric depict a chalk a defect contour. Patch edges should be more than the damaged site on 1 - 2 see Separately make an overlay under a patch which should be more than the patch on edge on 1 - 0,5 glue see squeeze out on pure glass a little and allow to it to dry up 4 - 6 minutes. With the dried up glue grease the humidified fabric, edges of a patch and an overlay. A backlash between edges of the damaged thing and patch edges too grease with a thin layer of glue. To a glutinous layer allow to dry up, then grease again. To the second layer also allow to dry up, then having imposed an overlay greased with glue fasten all utjuzhkoj (3 - 4 seconds). After a preliminary fastening of a patch a thing overturn, put from above a damp rag and maintain under an iron of 20 seconds. Endurance under a hot iron repeat 2 - 3 times, moistening a rag.
If the knitted product has torn, it can be dismissed. Threads should be connected so that there were ends 1 - 2 sm which then get involved or fill from a seamy side. The wool should be winded in hanks, to tie up in several places and to wash.
Hanks hang up in a thread direction. It is necessary to dry, having attached to the bottom part small cargo that threads were levelled. When threads will dry out, them without a tension take up in balls. Now they can be used for a new thing.
Sometimes by partial restoration it is possible to change a product style, for example, of a long jacket to make short or from the short long. For this purpose dismiss the bottom loops or, keeping a pattern, dovjazyvajut a thing till necessary length.
In the Same way the worn out elastic bands of sleeves and a bottom replace new. For this purpose it is possible to use a yarn of another, but only suitable colour.
The Worn out sleeves can be removed and made a jumper without sleeves, having finished projmy an elastic band, or to dismiss sleeves, and then to connect the new.
Procarved pockets wear out along the edges. To repair them, unpick paper clips on pockets, unstitch the bottom framework, unscrew obtachku on a face sheet. Then it unpick and worn out edge cut off. After utjuzhki obtachku sew on bottom edges. A seam razutjuzhivajut. If the width obtachki is insufficient also a spare material is not present, it is necessary to use a fabric from under a board. For manufacturing of a framework of a pocket at repair often use the pocket valve without which the thing does not lose a kind. Sewn obtachku wrap in a pocket and, zametav framework edge, prostrachivajut it in the area of a seam. Upon termination of paper clip repair put along the edges of a pocket where they were earlier. A pocket sacking if it is worn out only in the bottom part, cut off to a strong place and again prostrachivajut or lengthen.
The Button sew, not strongly drawing to a material, and leaving a thread a little free. Formed thus "ё=хсхыхъ" it is necessary to wind some times with a thread. It becomes that the loop clasped a button freely, was not pulled together. And "ё=хсхыхъ" should be longer at more dense fabric and is shorter at the easy. The button can be sewn to silk without "ё=хсхыіър" not so strongly pulling a thread. Sewing buttons to outer clothing, it is necessary to enclose from outside linings a small button or a fabric piece - for durability.
Buttons sew in those places where the fabric not strongly stretches. That the sewn buttons have settled down precisely against each other, it is necessary to sew at first the top part of the button, on its head to make a mark a chalk. To an opposite side on the printed place to put the significant other of the button and to sew.
<< the previous page